Latest news

Release 4.10.1 - Another Docker fix release

This release is again for Docker users only. Somehow the Docker health check is working differently, and that was killing the container before the software could start. So the health check is changed, and should wait for a maximum of three minutes to startup before restarting the container when unhealthy.

And for the Bullseye Docker image, there was an OS package missing which made not to start up. This has also been fixed.

Release 4.10.0 - Make GPIO relays work like they should

GPIO relay changes

In this release we have changed the GPIO relay code. So if you use those relays, pay attention to the following.

Release 4.9.2 + 4.9.3 - Docker fixes

The Docker builds where broken and should now be fixed again. That is all.

Upgrading

Get the new version here.

Or, go the installation page in order to install Terrarium PI version.

Release 4.9.1 - Fine tuning

Fine tuning total power and water usage

The previous release did improve the speed a lot with caching the total power and water usage. This saves a lot of CPU time with a big database.

Release 4.9.0 - More speed or less waiting

Speed up by adding more caching and threading

When TerrariumPI is running for a couple or years, you will get a lot of relay data which it used for the total power and water usage. After 7 years, it took about 15 seconds each time it was calculated. Which is half the time of the engine run time.